Leave a reply

3 comments
  • TO SETUP YOUR LINKSYS EA6350 YOU NEED TO FOLLOW THESE STEPS:-
    1. PLUG YOUR ROUTER TO A WALL SOCKET.
    2.CONNECT A ETHERNET CABLE FROM YOUR MODEM TO INTERNET PORT OF YOUR ROUTER .
    3.CONNECT A ETHERNET CABLE FROM PORT NO 4 TO YOUR COMPUTER .
    4. CHECK YOUR NETWORK STATISTICS BY DOING IPCONFIG ON CMD WINDOW.
    5. OPEN A BROWSER TYPE YOUR DEFAULT GATEWAY FOR LINKSYS EA6350 ACCESS IN ADDRESS BAR HIT ENTER.
    6.IT WILL GIVE YOU A SETUP WIZARD YOU NEED T0 FOLLOW THE STEPS AND YOU ARE GOOD TO GO NOW.
    IN CASE YOU FIND ANY PROBLEM FEEL FREE TO CALL US BACK ON 1-800-603-4024



    0



  • Steps To setup LINKSYS EA-6350-

    1.Connect your router into direct power socket.
    2.Connect a Ethernet cable from modem to router’s wan port.
    3.Connect another cable from lan port of router to Computer .
    4.Open your browser and type http://linksyssmartwifi.com or 192.168.1.1
    5.Setup wizard will appear just follow the steps and your router will be configured.



    0



  • In order to setup your Linksys Router you would have to go through the following steps mentioned below:-
    1) Make sure that the power cable is connected to the router and the router should be Powered ON.

    2) Connect one Ethernet cable from your modem to the router in the Internet Port.

    3) Connect any of your wireless device to the routers wifi network using the wifi name and the password mentioned at the back or on the bottom of the Wireless router and make sure you must have a good signal from the router

    4)Launch any of your web browser and enter “http://linksyssmartwifi.com” in the Address bar and press Enter

    (If you are unable to launch the Smart Setup, you can enter the default IP Address of the router, 192.168.1.1, or type myrouter.local in the browser’s Address bar.)

    5)You will see Linksys Smart Wifi Set up on the page

    6)Check the box that says “I have read and accepted the License Terms for using this software then click Next to proceed.”

    7)In the Updates for your router window, the Install future router updates automatically (recommended) is checked by default to allow automatic updates for better wifi range and better wifi signals and Click Next to proceed.

    8)Enter the wifi name and password that you wish to keep in the fields provided, and then click Next.

    9)Connect your wireless computer to the new wireless settings you used during setup

    10)You will see the message on the screen displaying “Your router is set up!” message, this means that your router is now successfully set up.



    0



Written by evelyn lejeune
Router Categories