0
Marcus
got 3 welkin range extenders n300. No WPS light when press was button.
How to setup belkin range extender n300?
Belkin.range not working
0 Subscribers
Submit Answer
0 Answers
Follow these steps-
Plug your extender into wall socket .
-There are 3 ways to setup :-
1st option-Connect a cable from extender to your computer .
-Open command prompt and type IPCONFIG .Check the default gateway for ethernet .
-Use that IP to open setup page and follow the steps to configure it.
2nd option-Using your wireless device connect on extender open network .
-Once connected open browser and type http://belkin.range .
-Setup wizard will appear .Follow the steps to complete the setup.
3rd option-Using WPS .
-Press WPS on router for 3 seconds then press on extender for 3 seconds .
-Wait until you see solid WPS LED on extender.
-Now check your host network name will appear as “Unknown_EXT” .
-Connect to it using same router password then open your browser and type http://belkin.range .
-Now you can configure network setting if needed .
Thanks Leo
Setup instruction belkin extender
-Keep you extender plugged off for 5 minutes.
-Now plug your extender in wall socket.
-Wait 2-3 minutes then press the reset pinhole for 20 seconds then unplug your extender without releasing reset button .
-Wait 10 seconds then plug it back and hold the reset for 10 seconds more .
We never released the reset button in this 40 seconds process .
-If all the Lights are back then wait 5 minutes otherwise unplug it and plug it back after 5 minutes.
1.CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
3.PRESS WPS BUTTON ON YOUR ROUTER AND YOU WILL SEE LIGHTS STARTS BLINKING ON YOUR EXTENDER.
4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK ONCE THE LIGHT WILL BE SOLID.
5.NOW ENTER THE ADDRESS FOR YOUR EXTENDER SET UP.
6.LOGIN WITH DEFAULT CREDENTIALS THERE.
7. IT WILL OPEN A SETUP WIZARD FOR YOU.
8.FOLLOW THE STEPS OF WIZARD AND YOU ARE GOOD TO GO NOW.