Leave a reply

3 comments
  • As you have mentioned that you have just upgraded the internet speed just reset your extender with the help of paper clip and re setup the extender.
    There are several ways to connect your Tp link extender i.e ethernet cable method ,wps method and many more but i am sharing wps method here for wps method you need to follow these steps:-
    1. connect your extender in a direct wall socket near by your router for setup.
    2. press wps button on your extender for 3-5 seconds.
    3. press wps button on your router (you can do it by accessing router main page also).
    4. it will be connected to your routers network.
    5. you will see your network name with ext affixed in it.(network name ext_2.4 ghz & 5ghz)
    6. connect to the same network .
    7. it will open a setup wizard for you.
    8. follow the on screen instructions and you are good to go now.
    (if problem still persists you can reset your device.)
    for any question & query feel free to call us on 1-800-603-4024



    0



  • I will suggest you to simply reset you’re extender and set it up again.
    follow this guide –
    Setting up tp-link extender is really easy using WPS button. Here are the steps you will need to follow,
    •First you will need to place the tp-link extender near to your router and then plug the power to WiFi extender.
    •Press the WPS button located at the tp-link extender and do the same on your router, within two minutes, tp-link extender will connect itself with the existing network.
    •Type http://tplinkrepeater.net or 192.168.0.250 in address bar ,if the setup is not working.
    •You will notice that the LED status will be solid green.
    Once your tp-link extender is connected with the existing network you can place the WiFi extender where the dead zones are at your location.



    0



  • First of all reset your extender and set it up again
    At the back of your extender there would be a reset pinhole .
    Using a paper clip reset your extender
    Press and hold it down for ten second when you see the lights starts blinking release the clip.
    Your extender will reboot once you see the green light is solid
    You extender is reset now

    Set-up instructions :-

    Plug your Range Extender into a power outlet near your main Router/AP.
    Push the WPS button on your main Router/AP first,
    then immediately push the WPS button on your Range Extender with in 2 minutes.

    Open the brower it will bring the setup wizard page
    Follow the instructions
    once its done you can connect your devices with extender ..



    0



Written by Shanny Miller
Router Categories